Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung | Nächste Überarbeitung Beide Seiten der Revision | ||
circuit_design:7_non_linear_applications [2021/09/23 00:25] tfischer ↷ Seitename wurde von circuit_design:7_non_linear_appilcations auf circuit_design:7_non_linear_applications geändert |
circuit_design:7_non_linear_applications [2021/09/25 05:12] tfischer |
||
---|---|---|---|
Zeile 1: | Zeile 1: | ||
- | ====== 7. Non-linear | + | ====== 7. Non-linear |
===== 7.1 Schmitt Trigger===== | ===== 7.1 Schmitt Trigger===== | ||
- | < | + | < |
- | * interaktive Animation einer Triggerschaltung: [[https:// | + | * interactive animation of a trigger circuit: [[https:// |
</ | </ | ||
===== 7.3 Timer 555 ===== | ===== 7.3 Timer 555 ===== | ||
- | Der Timer 555 wird nicht zu Unrecht gelegentlich als "the time machine" | + | The 555 timer is sometimes referred to as "the time machine" |
- | Bevor auf den Baustein selbst eingegangen wird, sollen kurz die verschiedenen Modi betrachtet werden: | + | Before discussing the device itself, the various modes should be briefly considered: |
- | ^Modus^weitere Bezeichnung^Erklärung^Anwendung^Beispiele^ | + | Mode^other name^explanation^application^examples^ |
- | |astabil|Oszillator, Multivibrator|Ausgangssignal wechselt periodisch den Wert|Erstellen eines periodischen, rechteckigen Signals, mit einstellbarer Pulsweite und Frequenz|Motoransteuerung, Dimmen von LEDs, Erzeugen von Tönen| | + | |astable|oscillator, multivibrator|output signal changes value periodically|creation of a periodic, rectangular signal, with adjustable pulse width and frequency|motor control, dimming of LEDs, generation of tones| |
- | |monostabil|"Kippstufe", | + | |monostable|"flip-flop", |
- | |bistabil|Flipflop|Setzen/Rücksetzen bei Über-/Unterschreiten von Schwellen|prellfreier Schalter, Schaltungen mit Hysterese|Zweipunktregler, z.B. für Heizelemente| | + | |bistable|flipflop|set/reset when thresholds are exceeded/fallen short|bounce-free switch, circuits with hysteresis|two-point controller, e.g. for heating elements| |
- | ==== 7.3.1 Vergleich | + | ==== 7.3.1 Comparison |
- | Zu sehen ist, dass es verschiedenste Anwendungen für dieses Bauteil gibt. Dabei kann man sich die Frage stellen, was die Anwendung dieses Bausteins von einem Microcontroller abgrenzt: | + | It can be seen that there are a wide variety of applications for this component. The question can be asked what differentiates the application of this component from a microcontroller: |
- | ^Eigenschaft^Microcontroller^Timer 555^ | + | ^Property^Microcontroller^Timer 555^ |
- | |Kosten | + | |Cost (single unit, 2018)|from 3ct (chin. µC, [[https:// |
- | |Kosten | + | |cost (> |
- | |weitere Komponenten|Entstör-C| Entstör-C \\ Transistoren, Widerstände und weitere Kondensatoren \\ abhängig von der Anwendung| | + | |other components|interference suppression|interference suppression|transistors, resistors and other capacitors |depending on the application| |
- | |Komplexität|in Software|kaum vorhanden| | + | |Complexity|in software|hardly available| |
- | |Flexibilität|Updates | + | |Flexibility|Updates |
- | |Vorteile für kleine Stückzahlen|leicht durch programmieren änderbar, \\ keine Bauteilstreuung | + | |advantages for small quantities|easily changeable by programming, \no component scattering|easily changeable by reassembling on the board, \no software bugs, \no tools necessary| |
- | Lange Zeit war der Timer 555 die kostengünstigste Lösung für die oben erwähnten Aufgaben. Aktuell | + | For a long time, the Timer 555 was the most cost-effective solution for the tasks mentioned above. Currently |
- | + | ||
- | ==== 7.3.2 Pinning und prinzipielle Schaltung==== | + | |
+ | ==== 7.3.2 Pinning and principle circuit==== |