In every closed circuit and every mesh of the network, the sum of all voltages is zero!
Set the voltage on the power supply to $12~\rm V$ and measure this voltage precisely using a multimeter. Set up the measuring circuit shown in figure 1.
Add the voltage arrows and measure $U$, $U_{\rm 1}$ und $U_{\rm 2}$:
<tabcaption Table-4_mesh-set_V1 | Mesh set voltage mesurement> </tabcaption>
What is the mesh set here?
Check the formula with the measured values:
The resistors $R_{\rm 1}$ and $R_{\rm 2}$ connected in series form a voltage divider.
$$ \frac{U_1}{U_2} = $$
At each junction point, the sum of all incoming and outgoing currents is equal to zero!
Set the voltage on the power supply to $12~\rm V$ and measure the voltage accurately with a multimeter. In the first step, set up the measuring circuit shown in figure 2:
Draw the arrows for the directions of currents $I_{\rm 1}$ and $I_{\rm 2}$ in figure 3. The DC current measurement range must be set on both multimeter using the rotary switch. Then measure currents $I_{\rm 1}$ and $I_{\rm 2}$ and enter the measured values in table 1.
$$ \frac{I_1}{I_2} = $$
Switch the power supply back on and measure the current $I$. Enter its value in table 1.
$$ I=\frac{U}{R_{KP}} = $$