This is an old revision of the document!



In every closed circuit and every mesh of the network, the sum of all voltages is zero!
Set the voltage on the power supply to $12~\rm V$ and measure this voltage precisely using a multimeter. Set up the measuring circuit shown in figure 1.

mexlefirst_public:fig-1_mesh-set_v1.svg
Fig. 1: Mesh-set

Add the voltage arrows and measure $U$, $U_{\rm 1}$ und $U_{\rm 2}$:

  1. task-type-table

mexlefirst_public:table-1_mesh-set_v1.svg

 <tabcaption Table-4_mesh-set_V1 | Mesh set voltage mesurement> </tabcaption>

What is the mesh set here?



Check the formula with the measured values:



The resistors $R_{\rm 1}$ and $R_{\rm 2}$ connected in series form a voltage divider.

  1. task-type-freetext What is the ratio between the voltages $U_{\rm 1}$ and $R_{\rm 2}$?

$$ \frac{U_1}{U_2} = $$


At each junction point, the sum of all incoming and outgoing currents is equal to zero!
Set the voltage on the power supply to $12~\rm V$ and measure the voltage accurately with a multimeter. In the first step, set up the measuring circuit shown in figure 2:

mexlefirst_public:fig-3_v1-node-set-1.svg Fig. 2: Node-set circuit 1

Draw the arrows for the directions of currents $I_{\rm 1}$ and $I_{\rm 2}$ in figure 3. The DC current measurement range must be set on both multimeter using the rotary switch. Then measure currents $I_{\rm 1}$ and $I_{\rm 2}$ and enter the measured values in table 1.

  1. task-type-table mexlefirst_public:fig-4_v1-node-set-2.svg

Fig. 3: Node-set circuit 2

  1. task-type-freetext What is the relationship between currents $I_{\rm 1}$ and $I_{\rm 2}$?

$$ \frac{I_1}{I_2} = $$

Switch the power supply back on and measure the current $I$. Enter its value in table 1.

  1. task-type-table mexlefirst_public:table-5_node-set_v1.svg
Tab. 1: Node set current mesurement
  1. task-type-table Determine the node set for node K and check its validity.


  1. task-type-result Using the measured values for resistors $R_{\rm 1}$, $R_{\rm 2}$, and $R_{\rm 3}$, calculate the total resistance $R_{\rm KP}$:


  1. task-type-freetext Using the calculated value $R_{\rm KP}$, check the measured value of the total current:

$$ I=\frac{U}{R_{KP}} = $$