Nonlinear resistors
All resistors examined so far are linear resistors, for which the characteristic curve $I=f(U)$ is a straight line, s. figure 1.
The resistance value of a linear resistor is independent of the current $I$ flowing through it or the applied voltage $U$.
Fig. 1: Characteristic curve of a linear resistor
With nonlinear resistors, there is no proportionality between current and voltage. The characteristic curve of such a resistor is shown in figure 2. With these resistors, we talk about static resistance ($R$) and dynamic (or differential) resistance ($r$). The static resistance is determined for a specific operating point: at a specific voltage, the current is read from the resistance characteristic curve.
The calculation is performed according to Ohm's law:
$$ R = \frac{U}{I} $$
The differential resistance around the operating point is calculated from the current difference caused by a change in the applied voltage:
$$ r = \frac{\Delta U}{\Delta I} $$
Fig. 2: Characteristic curve of a nonlinear resistor
A light bulb is examined as an example of a nonlinear resistor. Set up the measuring circuit shown in figure 3.
Fig. 3: Measuring circuit light bulb
Set the voltage on the power supply to the voltage values from table 1. Measure the corresponding current values and enter them in table 1.
- task-type-table
- task-type-oscilloscope Create the characteristic curve $I = f(U)$, s. figure 4
Fig. 4: Characteristic curve light bulb
- task-type-result Calculate the static resistance $R$ at the operating point $U = \rm 7.0 ~V$:
- task-type-result Calculate the dynamic resistance $r$ at the operating point $U = \rm 7.0 ~V$:
- task-type-freetext Compare the values with the values from table ## (direct resistance measurement)