This is an old revision of the document!
Mesh set
In every closed circuit and every mesh of the network, the sum of all voltages is zero!
Set the voltage on the power supply to $12~\rm V$ and measure this voltage precisely using a multimeter. Set up the measuring circuit shown in figure 1.
Add the voltage arrows and measure $U$, $U_{\rm 1}$ und $U_{\rm 2}$:
- task-type-table
<tabcaption Table-4_mesh-set_V1 | Mesh set voltage mesurement> </tabcaption>
What is the mesh set here?
Check the formula with the measured values:
The resistors $R_{\rm 1}$ and $R_{\rm 2}$ connected in series form a voltage divider.
- task-type-freetext What is the ratio between the voltages $U_{\rm 1}$ and $R_{\rm 2}$?
$$ \frac{U_1}{U_2} = $$
Set of nodes
At each junction point, the sum of all incoming and outgoing currents is equal to zero!
Set the voltage on the power supply to $12~\rm V$ and measure the voltage accurately with a multimeter. In the first step, set up the measuring circuit shown in figure 2:
Draw the arrows for the directions of currents $I_{\rm 1}$ and $I_{\rm 2}$ in figure 3. The DC current measurement range must be set on both multimeter using the rotary switch. Then measure currents $I_{\rm 1}$ and $I_{\rm 2}$ and enter the measured values in table 1.
- task-type-table
- task-type-freetext What is the relationship between currents $I_{\rm 1}$ and $I_{\rm 2}$?
$$ \frac{I_1}{I_2} = $$
Switch the power supply back on and measure the current $I$. Enter its value in table 1.
- task-type-table
- task-type-table Determine the node set for node K and check its validity.
- task-type-result Using the measured values for resistors $R_{\rm 1}$, $R_{\rm 2}$, and $R_{\rm 3}$, calculate the total resistance $R_{\rm KP}$:
- task-type-freetext Using the calculated value $R_{\rm KP}$, check the measured value of the total current:
$$ I=\frac{U}{R_{KP}} = $$
</WRAP>